TA Triumph-Adler CX 8682 - Manual (Page 111)

PRINT JOB
U1 Plot 111
printing settings in the job editor don’t match to the settings
of the plotter. Maybe you have selected a medium which
isn’t installed in the plotter or the image is bigger than the
width of the plotter roll. Change either the settings in the job
editor, the image itself or the settings of the plotter.
• Sheet ID: ... is not part of this SSL. Cancel this job...
A job has been canceled. Through there not every entry has
been printed. You tried printing this job again. Thereby you
have been asked, if you want to print the whole job again or
just the missing entries. After you had chosen the latter
option this error message appeared. The reason is, that the
entries have been deleted. Try to print the complete job
again.
• Error while opening the Ssl file ... - while
processingcode at:...
Maybe a file is missing or it is defective. Try to open all
images in the file viewer. If one of the entries fails, you can
delete the defective entry and print the job again. If the
images are shown in the file viewer in spite of the error
message, it will be an internal program error. Ask your
dealer or a support technician.
• Error while reading file: ...
See above.
• Set2Single terminates job ... , because there's no
entry to generate.
There are no entries in the job. You have to create a new
job.
• Module Set2Single could not find the file: ...
A file is not available. A certain, preselected time of waiting
is observed until this error message appears. You have to
create a new job.
• Module Set2Single could not find the file: ... and
thus terminated job ...
The job was canceled after a missing file wasn’t found.
• Module Set2Single terminates job ... , because the
processing of file ... causes an unhandled exception.