Thermo Pride Air Handlers ECM Blower 13/14 SEER (AH2) - Manual (Page 3)

1
SAFETY SECTION
This page contains various warnings and cautions found throughout this Service and Installation Manual.
Please read and comply with the statements on the cover and the statements below.
: Improper installation, adjustment, alteration, service, or maintenance can cause injury
or property damage. Refer to this manual. For assistance or additional information consult a
qualified installer, service agency, or manufacturer listed below.
: If drilling or screwing into panel or plate is necessary, make certain drill or screw does not
penetrate into any part of evaporator coil or hot water coil and cause damage. Personal injury and/or
property damage may result.
: Do not use this system if any part has been under water. Immediately call a qualified
service agency to inspect the system and to replace any part of the electrical or control system which has
been under water.
: The cooling and heating coils must be cleaned by a qualified service person.
: This air handler is not to be used to condition during construction.
: When testing electrical equipment, always follow standard electrical procedures and
precautions.
: DO NOT wet electronic components during hydronic testing. Wetting electronic
components may damage circuitry and cause a hazardous situation. Dry moisture from all leads and
terminals if wetting occurs. Wait at least 24 hours for the circuit to fully dry before energizing the system.
: Personal injury or property damage could result from major repair or service of this system
by anyone other than a qualified contractor.
: If you do not follow these instructions exactly an unsafe condition may result causing
personal injury, loss of life or property damage.
Installation and service personnel are required by some states to be licensed. Persons not qualified shall
not install this equipment nor interpret these instructions.
All local codes and regulations take precedence over the instructions in this manual and should be
followed accordingly. In the absence of local codes, installation must conform with these instructions,
regulations of the National Fire Protection Association and provisions of the National Electric Code.