Thermo Pride Air Handlers ECM Blower 13/14 SEER (AH2) - Manual (Page 5)

3
9. Remove screws that secure the blower pan to the side & rear casings.
10. Push the front edges of the side casings slightly apart and remove the blower pan.
11. Remove screws from the return air end panel and side & rear casings.
12. Remove side & rear casings from the return air end panel.
REASSEMBLY OF AH2436
To reassemble the air handler, reverse steps above starting with number 12.
Figure B.
FOLLOW THESE STEPS FOR KNOCKDOWN OF AH4260
1. Start with unit setting in a vertical position (Figure B).
2. Remove the blower access door and front A-coil access panel.
3. Remove front tie panel (four screws).
4. Remove four screws between left/right side blower module casings and left/right side coil module
casings.
5. Remove two screws between rear blower module casing and rear coil module casing.
6. Top blower section is now disengaged from bottom coil section. Lift top off of bottom section.
7. If the Air Handler needs to be completely knocked down, follow steps in procedure for the
knockdown of the AH2436.