SAF-HOLLAND XL-TA10006OM Drum Brake Axles Tapered and Parallel Spindle Axles - Manual (Page 21)

21 XL-TA10006OM-en-US Rev B · 2014-03-13 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Brake Shoe Replacement
Figure 35
Figure 37
Figure 36
7. Position the roller of the lower brake shoe up against the
S-Cam, then place the other end of the shoe against the
anchor pin (Figure 35).
8. Install the two (2) brake anchor pin springs using the
anchor pin pliers (Figure 36).
9. Make sure the brake linings are clean.
10. Re-install drum using support device such as a drum dolly
jack (Figure 37).
Failure to support weight during installation
or removal of brake drum could create a
crush hazard which, if not avoided, could
result in minor to moderate injury.
11. Adjust the brakes as described in Section 17.
UPPER BRAKE SHOE
LOWER BRAKE SHOE
S-CAM
ANCHOR PINS
SPRING PLIERS
BRAKE ANCHOR PIN SPRING