SAF-HOLLAND XL-TA10006OM Drum Brake Axles Tapered and Parallel Spindle Axles - Manual (Page 23)

23 XL-TA10006OM-en-US Rev B · 2014-03-13 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
S-camshaft Replacement
Figure 41
Figure 42
15. S-Camshaft and Bearing
Removal Procedure
1. Remove the brake shoes and brake adjuster as described
in Section 11 and 13, respectively.
2. Remove the retaining ring from the spider end of the
S-Camshaft (Figures 41).
3. Remove the S-Camshaft by sliding it out of the S-Camshaft
bearing housing and bearings. It could be necessary to
tap the end of the shaft with a soft mallet to release it
from the bearings (Figure 41).
4. Remove existing bolts securing the S-Camshaft bearing
housing to the axle bracket (Figure 42).
5. Inspect bearings assembly for wear and deterioration.
Replace as necessary.
RETAINING RING
BRAKE SPIDER
S-CAMSHAFT
BOLTS (4)
S-CAMSHAFT BEARING HOUSING
AXLE BRACKET
AXLE BRACKET