Amprobe AT-4000 Advanced-Wire-Tracer - Manual (Page 19)

T-4000
R-4000
B2024
17
Locating Outlets From The Breakers Panel
1. Connect the A2202 Clamp-on to the T-4000 Transmitter and then clamp it around
the conductor.
2. Set the T-4000 to ‘HIGH’ signal level.
3. Set the R-4000 to ‘OPEN’ mode and ‘LOW’ sensitivity.
4. Hold the R-4000 in front of each suspected outlet or piece of equipment. If it is on the
same wire as the clamp, the R-4000 will indicate it.
5. If a known outlet does not produce a signal, use the B2024 to boost the signal.
(Refer to Figure 19)
Note: When using the battery booster (B2024 or B2025) the unit will work in ultra
high “U-HI” mode only. Remove the battery booster to return to normal operation.
Fig.19
Locating Buried Conduit or Metal Pipe
1. Connect the A2202 clamp-on to the T-4000 Transmitter and then clamp it around
the conduit or pipe.
2. Use of the B2024 battery or the B2025 converter is recommended.
3. Set the T-4000 to ‘HIGH’ mode.
4. Set the R-4000 to ‘SHORT’ mode and ‘LOW’ sensitivity.
5. Trace the conduit. (Refer to Figure 20)
Note: When using the battery booster (B2024 or B2025) the unit will work in ultra
high “U-HI” mode only. Remove the battery booster to return to normal operation.
Fig. 20
T-4000
B2024