Amprobe AT-4000 Advanced-Wire-Tracer - Manual (Page 21)

REPLACEMENT PARTS
9V Battery.................................................................................................9V Alkaline
Clamp-On Transmitter Accessory..............................................................A2202
Battery Pack..............................................................................................B2024
10V Converter/Recharger...........................................................................B2025
110V Pigtail - Banana Plug Cord Set.........................................................C2901
Alligator - Clip Banana Plug Cord Set........................................................C2902
Grounding Test Lead 25-FT.......................................................................MTL-G
Alligator Clip..............................................................................................VRC-320
Carrying Case AT-4000.............................................................................CC-AT-4000
Owners Manual........................................................................................
www.Amprobe.com
Fuse 1000V 0.25A FA 6X46MM................................................................FA6X46MM
TROUBLE SHOOTING
Symptom
LCD Segments of the
T-4000 are fading
R-4000 Can’t detect signal
Possible Cause
9V battery is low in voltage
a) Wrong Mode or Range
b) Transmitter is OFF or the
signal level is too low
c) Signal Cancellation
Solution
Replace the battery
a) Ensure that you are using
the right mode or range.
(See application notes)
b) Turn ON the transmitter
and select the appropriate
signal level.
c) Use a separate ground or
separate the wires.
19