EnGenius Technologies DuraFon 4X - Manual (Page 14)

25
Note:
1. The handset packaged along with a Base Station is pre-
registered at the factory. If you have a new handset, you will
need to register the handset with the base station in order to be
recognized as a member handset by the base and by other
handsets. See Handset Registration.
2. Fully charge battery packs before the first usage.
26
Basic Operations
Operation Modes
Both the base station and handset have levels of operation at
which time only certain procedures of functions can be performed.
A. Base Operation Modes
1. IDLE mode- this is the default mode. The intercom, broadcast,
and volume keys are active in IDLE mode.
2. TALK mode- the base operates in this mode during phone
call, intercom, and broadcast operation. The “In Use”,
“Intercom”, and “Broadcast” LED will light up respectively.
3. REGISTRATION mode- the base enters this mode by
pressing the REG button for three seconds. There are no
active base unit keys once this mode has been entered. Four
LEDs will light up in Registration mode.
B. Handset Operation Modes
1. IDLE mode- this is the default mode.
a. If there is no on-going activity, the handset automatically
goes into SLEEP/IDLE mode to save battery power.
b. The handset can be turned off completely by holding
down the END key for 3 seconds.
c. The idle screen display (custom name) can be edited.
d. The 2-digit number represents the handset ID.
2. Menu mode
a. Press the Right soft function key to activate MENU mode.
b. In MENU mode, the handset settings and information
contained in memory can be changed.
c. The functions available through the MENU selection are
covered in greater detail from page 50.
d. The MENU structure display as below: