EnGenius Technologies DuraFon 4X - Manual (Page 23)

43
proper programming and “call transfer” feature
code (available from the user manual of the wired
PBX system) in order to perform this function
correctly.
The following example is the instruction to route a
call back to the brand N’s PBX system by
pressing “Flash-7-0-1-8-3-0,” where a Flash key is
pressed followed by the call transfer code”70”,
then enter the extension number “1830”
immediately. Confirm the set up by press “SAVE”
using the left soft key.
Notes:
1. Only administrator can change AA settings.
2. Because AA setting is stored on the base station, the handset
must be in range with the base to make changes.
3. The maximum recording time for the greeting message is 128
seconds.
4. Allowing each line’s AA to be turned on or off separately is
useful if different lines are used for different purposes.
5. When AA is disabled, the line can be dedicated to either an
individual Handset ID or a Group ID.
6. The operator can be any individual handset or a group; it
doesn’t need to be an administrator handset (Handsets 10 and
11).
7. The minimum number of rings before the AA picks up cannot
be lower than two for the purpose of receiving the Caller ID
message.
Line Dedication:
a. By default all incoming calls will ring all handsets.
b. To dedicate a handset to a specific line you must use an
administrative handset (ID 10 or 11).
c. With the administrative handset, press Menu-9-1-4 for
Auto Attendant On and OFF . It will first show Line 1
ON/OFF. If you wish to dedicate line 1 to a specific
handset you need to select “Off”. This will turn off auto