Canon EOS 80D - Manual (Page 292)

W-44
Sending Images to a Camera
5
Select [Send].
X The selected images will be sent.
When the transfer is complete, the
screen for step 1 will reappear.
 To send other images, repeat steps 1
to 5.
6
Terminate the connection.
 Press the <M> button to display
the confirmation dialog. Select [OK],
then press <0> to terminate the
connection.
X The [Wi-Fi function] screen will
reappear.
 While connected, a picture cannot be taken even if the camera’s shutter
button is pressed. When you want to terminate the connection to shoot
or perform other operations, press the <M> button, then terminate
the connection on the displayed screen. To terminate the connection
during image transfer, select [Cancel] on the camera, then terminate the
connection.
 When sending a large number of images or large files (total size), make
sure that the battery is adequately charged so it does not run out during
the process.
 Depending on the functionality of the target camera, the movie files will
be converted when they are sent. Therefore, transfer may take longer
than usual.
 RAW images cannot be sent.
 You can select up to 50 files at a time.
 When you reduce the image size, all images to be sent at the same time
are resized. Movies, as well as still photos that are smaller than b size,
are not reduced.
 [Resize:S2] is enabled only for still photos shot with cameras of the same
model as this camera. Still photos shot with other models are sent without
resizing.
 You can cancel the image transfer by selecting [Cancel] during the
transfer. When [Cancel] is selected on the camera sending the images,
the image selection screen will reappear. When [Cancel] is selected on
the camera receiving the images, the connection will be terminated.
 While connected, the camera’s auto power off does not function.