Sharp MX-6070N - Manual (Page 16)

16
General Problems
THE OUTPUT IS NOTICEABLY CURLED AND UNEVEN
Check Solution
Remove the paper, turn it over, and
reload it. Using a different paper type
may solve the problem. ■ This may improve some states of paper curling.
► Placing the original and adding paper (page 5)
THE IMAGE IS SKEWED ON THE PAPER
Check Solution
Is too much paper loaded into the
bypass tray? ■ Reload the paper. Load no more than the maximum number of sheets and do not
exceed the indicator line.
The maximum number of sheets varies depending on the paper type setting.
Are the bypass tray guides adjusted
to the width of the paper? ■ Adjust the bypass tray guides to the width of the paper so that they slightly
contact the sides of the paper.
Are the original guides adjusted to the
width of the paper? ■ Adjust the original guides to the width of the paper.
Is the control plate auxiliary block
attached to the tray? (When using
SRA3) ■ Attach the control plate auxiliary block.
Are you scanning originals of mixed
width? (In a reversing single pass
feeder (RSPF)) ■ If the printed image is skewed when you have scanned originals of mixed width,
open the document feeder cover, change the switch position, and place the
originals.
The A position of the switch is for normal scanning. The B position is for scanning
of mixed originals.
Be sure to set the switch back to the A position after the mixed original job is
finished.
?
!
?
!
B
A