Compactflash memory card, Led behavior, Table a-3 led description – Enterasys Networks XSR-3150 User Manual

Page 107

Advertising
background image

Cable, CompactFlash and Accessory Specifications

XSR Getting Started Guide A-21

CompactFlash Memory Card

The optional plug-in CompactFlash (CF) memory card, shown in

Figure A-27

, comprises a single

chip controller and flash memory modules in a matchbook-sized package with a 50-pin, PCMCIA
connector consisting of two rows of 25 female contacts each.

The PCMCIA male interface supports both Type I and Type II CF cards. Note that the CF release
mechanism pops out when you install the card. For installation instructions, refer to the Hardware
Installation
chapter.

Figure A-27 CompactFlash Memory Card

LED Behavior

The 14 LEDs on the XSR front panel display system and port status as described in

Table A-3

. The

six system LEDs are illustrated to the left and the eight GigabitEthernet LEDs to the right in

Figure A-28

. Note that Link and TX (transmit) green LEDs are provided for the GBIC (optical) port

while each GigabitEthernet port has one green and one amber LED.

Figure A-28 XSR LEDs

Pin 50

Pin 1

Table A-3 LED Description

LED

State

Function

NIM 1, NIM 2

ON

T1/E1, ISDN or HSSI card is present and power-
up diagnostics test passed

OFF

NIM slot empty or power-up diagnostics test failed

SYS(tem Status)

ON

XSR is operational

OFF

Faulty hardware or Bootprom

Blinking

Flash update is in progress (software image
downloading), warning you not to power down the
XSR. Powering down now can leave the branch
router without valid software.

PWR

ON

XSR is powered up and Bootrom initialized

OFF

XSR is powered down

COM

PWR

SYS

NIM1

NIM2

VPN

1000

GBIC

Link

TX

ETH3

ETH2

ETH1

10/100/1000

10/100/1000

Advertising