Configure snmp -26, Configure snmp – Enterasys Networks XSR-3150 User Manual
Page 70
Frame Relay WAN Link with PPP Backup Sample Configuration
3-26 Software Configuration
XSR(config-if<D1>)#encapsulation ppp
+
Enables PPP encapsulation
XSR(config-if<D1>)#ip address 192.31.27.84 255.255.255.0
+
Sets the IP address on the interface
XSR(config-if<D1>)#dialer string 4165557922
+
Sets dialer phone #
XSR(config-if<D1>)#dialer wait-for-carrier 30
+
Specifies the period the XSR will wait for a connection from the service provider
XSR(config-if<D1>)#di pool 1
+
Specifies the dial pool from which calls originate
XSR(config-if<D1>)#no shutdown
+
Enables the dial interface
Configure SNMP
The previously configured ACL will be applied to all SNMP requests. Stricter ACLs can be written
if tighter security controls are required.
XSR(config)#snmp-server community toMonitor1 ro 26
+
Adds an SNMP community with read-only privileges attached to ACL 26
XSR(config)#snmp-server community toConfigure1 rw 26
+
Adds another SNMP community with read-write privileges attached to ACL 26
XSR(config)#snmp-server enable traps
+
Enables traps to be transmitted
XSR(config)#snmp-server contact [email protected]
+
Specifies contact information for the management server
XSR(config)#snmp location “HQ 2nd floor”
+
Specifies the server locationr
XSR(config)#snmp-server host 192.168.2.101 traps trapCommunity
+
Specifies management station to send traps to
XSR(config)#snmp-server host 192.168.2.102 traps trapCommunity
+
Specifies another management station to send traps to