Enterasys Networks XSR-3150 - Manual (Page 75)

VPN Sample Configuration with Network Extension Mode
XSR Getting Started Guide 3-31
Generate the master key. Refer to the following sample key:
XSR(config)#crypto key master generate
New key is 2173 4521 3764 2ff5
163b 4bdf fe92 dbc1
1232 ffe0 f8d9 3649
Apply the following ACLs to the public interface of the XSR before creating the VPN
configuration. These ACLs are applied only to an XSR configured to terminate Network Extension
Mode (NEM) tunnels initiated from ANG-1100s. These ACLs allow all outbound IP traffic and
established inbound TCP traffic and employ well-known protocol numbers for IKE UDP (500) and
ICMP to and from the public interface (if preferred).
XSR(config)#access-list 1 deny 26.26.26.0 0.0.0.255
XSR(config)#access-list 1 permit any
XSR(config)#access-list 110 permit udp any any eq 500
XSR(config)#access-list 110 permit icmp any host 26.26.26.10
XSR(config)#access-list 110 deny ip any any
XSR(config)#access-list 111 permit udp any any eq 500
XSR(config)#access-list 111 permit icmp host 26.26.26.10 any
XSR(config)#access-list 111 deny ip any any
XSR(config)#interface gigabitethernet 2
XSR(config-if<F2>)#ip access-group 110 in
XSR(config-if<F2>)#ip access-group 111 out
Enable Network Address Translation:
XSR(config-if<F2>)#ip nat source assigned overload
Create the VPN virtual subnet:
XSR(config)#ip local pool virtual_subnet 10.10.10.0 255.255.255.248
Configure AAA authentication by assigning a virtual subnet to the DEFAULT AAA group,
associate it with DNS and WINs servers, and add two AAA users with passwords.
When a remote XSR tunnels into the local XSR, it will be assigned these DNS, WINS and PPTP
values and be assigned dynamically to the IP pool virtual_subnet. Be aware that users not added to
a specified group will automatically be assigned to the DEFAULT group and groups must be
created before users can be added to them. Remember to create the same users and passwords on
the remote XSRs.
XSR(ip-local-pool)#aaa group DEFAULT
XSR(aaa-group)#ip pool virtual_subnet
Configure DNS and WINS parameters:
XSR(aaa-group)#dns server primary 172.16.10.10
XSR(aaa-group)#dns server secondary 172.16.10.11
XSR(aaa-group)#wins server primary 172.16.10.10
XSR(aaa-group)#wins server secondary 172.16.10.11