Endura RADISYS KP915GV - Manual (Page 11)

KP915GV Product Manual
11
Product Specification Overview
Item Description
Network Intel 82573V (or ‘L) PCI-E Gbit Ethernet controller, co-lay with Intel 82562GZ
10/100 PHY (using the integrated MAC)
Available with second Intel 82573V (or ‘L) Gbit Ethernet controller
Disks Four SATA ports with locking headers
Single Ultra ATA/100 interface supporting hard disks and ATAPI drives
One FDD interface
Super I/O &
H/W Monitor Nat Semiconductor PC8374K Super I/O and Nat Semiconductor LM9600
hardware monitoring device
Automatic fan speed control based on thermal monitoring (note that the BIOS
Setup is used for configuration and status information)
Header
Connectors GPIO 2 x 10 pin with housing
SMbus 1 x 4 pin with housing
COM2 2 x 5 pin with housing
Kbd/Mouse 1 x 4 pin with housing
Remote thermal sensor 1 x 2 pin with housing
FDD 1 x FDD connector
1394b 2 x 5 pin connector
I/O Panel PS/2 keyboard and mouse
Analog VGA
Bi-directional/EPP/ECP parallel port
COM1 RS232
One or two dual USB + RJ45 stacks
Audio jack stack (2 jacks)
RadiSys PLD Lattice LC4128ZC-75TN100C PLD for watchdog, GPIO, BIOS write-protect
support
1.1 Accessories
There are two I/O shields, one for the single Ethernet configuration and one for the dual Ethernet
configuration, and an available fan heat sink for the processor. These are separately orderable
product codes.
ATX-L KP IOSHLD ATX I/O Shield for KP915GV