Roland V-1200HD Multi-Format Video Switcher - Manual (Page 24)

24
Connecting External Equipment
Connecting Audio Source Equipment
Making an Analog Connection
Connect the analog output of the audio source device to an AUDIO
IN connector.
Set the audio selector switch to [ANALOG].
NOTE
The audio selector switch affects both input and output. For
details, refer to “About the Audio Selector Switch” (p. 22).
Making a Digital Connection
Connect the digital (AES/EBU) output of the audio source device to
an AUDIO IN connector.
* Use an AES/EBU-compliant cable.
The V-1200HD supports the AES3 standard (24 bits, 48 kHz, two
channels).
Set the audio selector switch to [AES/EBU].
NOTE
The audio selector switch affects both input and output. For
details, refer to “About the Audio Selector Switch” (p. 22).
Connecting a Reference
You can connect a source device for synchronizing.
* You can also output a reference signal via the OUT/THRU
connector. For details, refer to the “V-1200HDR/V-1200HD RCS
Remote Control Guide” (PDF) available for download at the
Roland website.
The V-1200HD supports the following external clocks.
5 Black burst (frame synchronization)
5 Bi-level synchronization, tri-level synchronization
Memo
The clock source is set to “INTERNAL" by default. To use an
external clock, this setting must be changed using a V-1200HDR
unit or V-1200HD RCS. For details, refer to the “V-1200HDR/V-
1200HD RCS Remote Control Guide “ (PDF) available for
download at the Roland website.
http://proav.roland.com