Roland V-1HD+ Compact 4 x HDMI Video Switcher - Manual (Page 5)

5
Panel Descriptions
INPUT 1–4 connectors
* Do not block the ventilation openings (the slits located on the front and side panels, etc.). If the ventilation openings
are blocked, the internal temperatures may rise, causing malfunctions due to excessive heat.
Rear Panel (Connecting Your Equipment)
AUDIO IN 1, 2 jacks/LINE IN L, R jacks
These input audio. Connect a mic, audio mixer, CD
players, or other such audio equipment.
Phantom power settings
You can supply phantom power (+48 V) from the
AUDIO IN 1 and 2 jacks. Turn on phantom power when
you’re using a condenser microphone that requires
phantom power.
Use the [SETUP] button
0 “AUDIO IN 1” or “AUDIO IN 2”
0 set “PHANTOM +48V” to “ON.” When this is on, the
+48V indicator is lit.
NOTE
If you don’t need phantom power, be sure to turn phantom
power off. You risk causing damage if you mistakenly
supply phantom power to dynamic microphones, audio
playback devices, or other devices that don’t require such
power.
AUDIO OUT L, R jacks
These output the results of audio mixing. Connect an
audio recording deck, amplifier, speakers, or other such
equipment.
These input video. Connect a video camera,
video device such as a BD player, or a computer.
Pin assignment
AUDIO IN 1, 2 jacks AUDIO OUT L, R jacks
1: GND 2: HOT
TIP: HOT
RING: COLD
SLEEVE: GND
3: COLD
1: GND 2: HOT
TIP: HOT
RING: COLD
SLEEVE: GND
3: COLD
Audio output
jacks
Audio output jacks
RCA phono XLR XLR
1/4” TRS phone
HDMI output
connector