Samson Carbon 49 USB/MIDI Keyboard Controller - Manual (Page 16)

16
Edit Mode
ASSIGN TRANS
Press the ASSIGN TRANS key to change the function that the TRANSPOSE “+”
and “-” buttons control. There are three parameters that can be assigned:
1 - Transpose
2 - Program Change 3 - MIDI Channel
When pressed, the current function number will flash on the display. Rotate the
DATA knob, or enter the control code using the numerical keys. Press the ENTER
key to confirm the selection. If the number input is out of range, the display
will flash “-E-” (error) for three seconds, and then return to the last set function
number.
Note: When the TRANSPOSE button is set to 2 (program change) or 3 (MIDI
channel), the indicators will not work. In addition, when the TRANSPOSE button is
set to 2 (program change), the button has an accelerate feature (when the button
is pressed and held down, the number will rapidly change so that you can access
higher program numbers more quickly).
ASSIGN FADER
Press the ASSIGN FADER function key to adjust the controller number assigned to
the VOLUME fader. When pressed, the current controller number will flash on the
display. Rotate the DATA knob, or enter the controller number (0–148) using the
numerical keys. Refer to the MIDI Continuous Controller (CC) List on page 18 for
a list of codes and their corresponding functions. Press the ENTER key to confirm
your selection. If the number input is out of range, the display will flash “-E-”
(error) for three seconds, before returning to the last set CC number.
ASSIGN KNOB
Press the ASSIGN KNOB function key to adjust the controller number assigned
to the DATA knob. When pressed, the current controller number will flash on the
display. Rotate the DATA knob, or enter the controller number (0–148) using the
numerical keys. Refer to the MIDI Continuous Controller (CC) List on page 18 for
a list of codes and their corresponding functions. Press the ENTER key to confirm
your selection. If the number input is out of range, the display will flash “-E-”
(error) for three seconds, before returning to the last set CC number.
ASSIGN MOD
Press the ASSIGN MOD function key to adjust the controller number assigned to
the MODULATION wheel. When pressed, the current controller number will flash
on the display. Rotate the DATA knob, or enter the controller number (0–148)
using the numerical keys. Refer to the MIDI Continuous Controller (CC) List on
page 18 for a list of codes and their corresponding functions. Press the ENTER
key to confirm your selection. If the number input is out of range, the display will
flash “-E-” (error) for three seconds, before returning to the last set CC number.