Samson Carbon 49 USB/MIDI Keyboard Controller - Manual (Page 17)

17
Carbon 49 · USB/MIDI Keyboard Controller
EN
GL
ISH
FR
AN
ÇAI
S
DEU
TS
CH
E
ES
PA
Ñ
OL
IT
AL
IA
N
O
RESET ALL
The RESET ALL function sets all of the Carbon 49 controller values to their defaults. When
you press the RESET ALL function key, the display will first show “No” (indicating that you
do not want to reset all functions). If you do want to reset all controllers, press the numeri-
cal key 1, or rotate the DATA knob until “Yes” appears on the display. Press the ENTER key
to confirm, and all controllers will be reset instantly. If you press the ENTER key while the
display shows “No”, the reset will be cancelled.
ALL NOTES OFF
The ALL NOTES OFF function sends an “all notes off” message in order to stop any stuck
notes. Press the ALL NOTES OFF function key and the keyboard will instantly send the “all
notes off” message, and any sustaining notes should stop.
DEFAULT
The DEFAULT function returns all of the Carbon 49 parameters to the original factory set-
tings. Press the DEFAULT function key, and the display will show “No” (indicating that you
do not want to reset to all default, factory settings). If you do want to reset all controllers
to their factory settings, press the numerical key 1, or rotate the DATA knob until “Yes”
appears on the display. Press the ENTER key to confirm, and all controllers will be reset
instantly. If you press the ENTER key while the display shows “No”, the reset will be can-
celled.
SNAPSHOT
The SNAPSHOT function transmits all of the current controller values for the
VOLUME fader, DATA knob, PITCH BEND wheel, program number, and channel
number at once, so that you can get a full picture of your current settings. Press
the SNAPSHOT key to view these values.
Edit Mode
Keyboard Settings
ASSIGN PEDAL
Press the ASSIGN PEDAL function key to adjust the controller number assigned
to the SUSTAIN PEDAL input. The default setting is CC #64. When pressed, the
current controller number will flash on the display. Rotate the DATA knob, or enter
the controller number (0–148) using the numerical keys. Refer to the MIDI Con-
tinuous Controller (CC) List on page 18 for a list of codes and their corresponding
functions. Press the ENTER key to confirm your selection. If the number input is
out of range, the display will flash “-E-” (error) for three seconds, before returning
to the last set CC number.