Changing the ir remote code set, Turning the display on, Turning the display off – Planar Systems UltraRes P Series 49" UHD 4K Commercial Monitor User Manual
Page 40: Adjusting the volume, 6 changing the ir remote code set, 7 turning the display on, 8 turning the display off, 9 adjusting the volume
Page | 40
Planar UltraRes P Series User Manual
020-1407-02A
16.6 Changing the IR Remote Code Set
The IR remote code set transmitted by the remote and accepted by the display can be
configured. This is useful if there are multiple Planar displays and you would like each remote to
work only with one of the displays. It can also be used if IR interference with another device,
such as a DVD player, is occurring.
To change the IR code on the remote, use the following procedure:
1. Press and hold the CODE button on the remote control until the LED on the remote
lights solid red (approximately five seconds).
2. Enter a new five-digit code between 00000 and 65535. Include leading zeros for codes
with four or fewer digits; for example, enter 255 as 00255.
3. The LED turns off to confirm the code change. If you enter an invalid code, the LED
flashes for three or four seconds. Try again, entering a valid code.
Note:
The code must match the IR Remote ID Code setting. See page 74.
Note:
This feature requires the IR remote part # 952-0086-00. This remote ships standard with
the URP75, URP85 and URP98. To use this feature on URP49 / URP55 / URP65, the remote
must be ordered by contacting Planar.
16.7 Turning the Display On
1. Insert the power cord into the display and into the power outlet.
2. Ensure the AC
switch is set to “—“.
3. Press the ON button on the remote or the power button on the keypad.
16.8 Turning the Display Off
With the power on, press the OFF button on the remote or the power button on the keypad to
put the LCD panel
in a standby mode. To turn off power completely, turn the AC switch to “O” or
disconnect the AC power cord from the power outlet.
Note:
The display may automatically turn off the backlight or enter standby mode if no signal is
present for a certain period of time. See the description of the Power Saving Mode setting on
page 52 for more information.
16.9 Adjusting the Volume
1. Using the remote, press the vol + or vol - to increase or decrease the volume. You can
also use the Up and Down keys on the remote and keypad to increase or decrease the
volume.
2. Press the mute button to temporarily turn off all sound. To restore the sound, press the
mute button again.
Note:
The analog audio out is variable. S/PDIF is fixed.