EverFocus EMV400 - Manual (Page 11)

3
1.3 SPECIFICATIONS
EMV400 - 4CH Mobile DVR
Video Format NTSC/PAL (auto detected by system)
Operating System Embedded Linux with special small monitor friendly GUI
Video Input 4 channels (vibration resistant locking Molex connectors – Interface
cables to BNC-F supplied: two groups of 2 cameras each)
Video Output Main monitor: 1 composite BNC rear panel / 1 front panel RCA
output
Video Compression H.264
Recording Resolutions NTSC: 720x480/720x240/360x240
PAL: 720x576/720x288/360x288
Audio Inputs 4 line in (vibration resistant locking Molex connectors - Interface
cables to RCA-F supplied: two groups of 2 cameras each)
Audio Outputs 1 front panel RCA line out
Alarm Inputs 6 alarm inputs (vibration resistant locking Molex connectors -
Interface cables supplied)
Alarm Outputs 2 alarm outputs (form “C”; contacts rated at 30V AC/DC @ 1 amp –
interface cables supplied)
Storage 2.5" HDD x 1(up to 1TB)
Recording Rate NTSC: D1 60FPS, 2CIF 120f FPS, CIF 240 FPS
PAL: D1 50 FPS, 2CIF 100 FPS, CIF 200 FPS
Per camera resolutions and record rates can be set individually per
camera through the OSD menus up to the maximum record
capacity of 240 NTSC (200 PAL) CIF equivalent FPS
Recording Mode Continuous recording, event recording, continuous + event
recording
(Rate and resolution in each mode set independently per camera)
Record Quality Adjustable in five levels per camera per Record Mode
Pre Alarm Recording Optional; 5 second interval
Playback Rate NTSC: D1 60 FPS, 2CIF 120 FPS, CIF 240 FPS
PAL: D1 50 FPS, 2CIF 100 FPS, CIF 200 FPS
Playback Search Time/date, event search
Video Loss Detection Yes
Event Alarm Fan failure, hard disk temperature, hard disk failure, hard disk full,
hard disk removed, power loss (after power is restored), network
loss, GPS loss, GPS speed, GPS fencing, G sensor limits