EverFocus EMV400 - Manual (Page 46)

38
4.3 RECORD SETTING
Figure 4- is a screenshot of the RECORD SETTING MENU. This menu is used to configure basic recording
settings.
Figure 4-7 Record Settings
4.3.1 Record
Record Overwrite: Check the box and the disk will begin overwriting when full. NOTE: Unless this box is
checked, THE DVR MUST STOP RECORDING WHEN THE DISK IS FULL. The use of record overwrite
is strongly recommended. If you do not use this feature, please be sure to make specific arrangements to
monitor/be notified when the disk is full.
Power Delay-On: Set the delay time to supply power to the DVR in order to avoid excess consumption at
ignition.
Power Delay-Off: Set the delay time to power off the DVR after ignition off. It can extend the recording
time after ignition off.
Time Stamp: Select if the time and date will display while recording. Choose the location for the time
display from Top, Bottom or Off.
Auto Erase Video: The hard drive will automatically erase video after it has been on the hard drive for the
selected number of days. To use the maximum hard drive space, choose “OFF”. (See Record Overwrite
and notes above.) This feature is useful if local rules and regulations require recorded video to be
discarded after a specific number of days, or to limit the retention of older recorded video to clear space in
anticipation of event recording.
Click button to return to the previous level of menu.