Escient MP-100 - Manual (Page 33)

P AGE 33
F IRE B ALL -MP I NSTALLATION & U SER ’ S G UIDE - M22002-01A1
C HAPTER 2 - S ETTING U P F IRE B ALL -MP
FireBall-MP Power States: On, Standby, Off
After the FireBall-MP unit is plugged in, the Standby LED located next to the power
button will flash until the startup process is complete. Please wait. This may take
several minutes.
When the Standby LED is OFF, the FireBall-MP is now in a standby or “sleep” mode.
There is no video output when FireBall-MP is in standby mode. Press the Power button
(on the front panel or on the remote) once and the video output is displayed on your TV.
The unit is now ON.
To change from the ON mode back to the standby or “sleep” mode, press the Power
button on the front panel or on the remote once.
If power is removed from FireBall-MP for any reason, including a power outage or if the
unit is unplugged, FireBall-MP will automatically return to the Standby state as soon as
power is restored. When FireBall-MP is turned on again, FireBall-MP will return to the
same source mode that it was in when power was lost.
To force the FireBall-MP to restart, PRESS and HOLD the Power button for 4
seconds, and release it when the standby LED starts blinking. When the Standby LED
is off and FireBall-MP has completed its startup process, press the Power button once to
turn on the FireBall-MP.
Please follow the guidelines
regarding Power ON and Power
Standby procedures.
FireBall-MP has four power
states:
1. ON - you will see video
output on your display.
2. STARTING (flashing LED)
3. STANDBY or SLEEP - no
video output, the Power
LED is lit constant, powered
but not running.
4. OFF - unplugged from the
wall.