Escient MP-100 - Manual (Page 44)

P AGE 44
F IRE B ALL -MP I NSTALLATION & U SER ’ S G UIDE - M22002-01A1
C HAPTER 3 - G ETTING S TARTED
What Is The Setup Process?
Setting up a FireBall-MP is very easy once the FireBall Server is connected to an
ethernet network and properly configured.
Upon power on, FireBall-MP will try to automatically locate and connect to a FireBall
server. Please refer to your FireBall’s User’s Guide for instructions on properly
connecting the FireBall Server to an Ethernet network.
If a FireBall server is not located, the FireBall-MP will continue to scan the network until
a server is found. You should check your FireBall server’s power status and Ethernet
connetion. The FireBall-MP and FireBall Server must be on the same Ethernet network.
Note: FireBall-MP can only connect to one FireBall Server at a time.