Eurotech Appliances EWF272EL - Manual (Page 27)

27 Specifications are subject to change without notice. See owner’s manual for additional details.
Stacked Laundry Closet Installations
WASHER AND VENTED DRYER
Eurotech’s front panel controls make it possible to install the washers and dryers in a cabinet or
closet. Installation should be carried out by a qualified person who is familiar with all local codes and
ordinances for electrical and plumbing connections. Incorrect installation may case damage and/or
injury.
Second-floor (above grade) installations must meet all local building codes.
Make sure there is a 1/2” (12 mm) minimum clearance between the units and the units and cabinet.
Opening Dimensions
The washer drain outlet should be positioned
at a height between 23” (584 mm) and 35”
(889 mm) from the bottom of the unit. Refer to
the owner’s manual for instructions.
See page 18 for venting requirements.
If you are installing the pair in a closet, it is
best to use louvered doors to ensure proper air
circulation.
WARNING!
These appliances must be properly
grounded. Refer to the owner’s manual
for instructions.
Make sure the electrical cords and hoses
behind the units are not cramped.
To reduce the risk of fire, vented dryers
must be exhausted OUTDOORS or the
equivalent.
Never cover the end of the dryer stub
or vent hose with anything to catch lint,
except for a UL-approved vent basket.
24-3/8"
619 mm
23" to 35"
584 to 889 mm
220V, 15 Amp
Single Phase
Outlet
115V, 15 Amp
Outlet
67" minimu
m
1702 mm
Hot and
Cold
Water
Drain
24"
610 cm
35" to v
ent
889 mm
12"
305 mm