Eurotech Appliances EWF272EL - Manual (Page 30)

30 Specifications are subject to change without notice. See owner’s manual for additional details.
Dishwasher Installations
Dishwasher Installations
UNDER-CABINET INSTALLATIONS
Cabinet Opening Dimensions
Water Supply and Electrical Connections
WARNING!
This appliance must be properly grounded. Refer to the owner’s manual for instructions.
Make sure the electrical cords and hoses behind the unit are not cramped.
Do not use an extension cord with this appliance.
The dishwasher comes with a 110–120 V, 15 amp electrical cord, a 5’ PEX inlet hose with 3/8”
compression fitting, and a corrugated drain hose.
The water supply flow volume should be at least 3 gallons (12 liters) per minute. The water pressure
should be 18–176 psi. For service convenience, a shut-off valve (not supplied) should be installed in the
supply line in an easily accessible location, such as beneath the sink.
The power supply receptacle should be installed in a cabinet or on a wall adjacent to the undercounter
space in which the dishwasher is installed. If the electrical cord supplied is not long enough or a hard
wire installation is needed, refer to the user’s manual for instructions.
The electrical and water supplies should
enter on the right side of the machine,
a maximum of 2” (50 mm) from the
back wall and 6-1/4” to 8-1/4” (159–210
mm) from the floor, depending on the
underneath cabinet height, as indicated in
the illustration at right.
The access holes should be round and
smooth and 1-1/2” (38 mm) in diameter.
Maintain a 1/8” (3 mm) minimum
clearance between the dishwasher and the
cabinet on all sides.
(1) Water supply line
(2) Shut-off valve (not supplied)
Be sure to run the PEX water
supply line, drain hose, and power
supply cord through the hole in
the cabinet before moving the
dishwasher into place.
23-15/16"
608 m
m
32" to 35"
813 to 890 mm
2"
50 mm
6-1/4" to 8-1/4"
159 to 210 mm
24-3/16"
614 mm