Eurotech Appliances EWF272EL - Manual (Page 32)

32 Specifications are subject to change without notice. See owner’s manual for additional details.
Dishwasher Installations
FITTING AN EDW294E CUSTOM DOOR PANEL
Model EDW294E can only be installed with a fully-integrated custom
door panel that extends from the toe kick to the counter top. The unit
comes with everything needed to make installing the door panel easy.
The door is predrilled for the panel’s mounting screws.
See page 15 for available colors and part numbers.
INSTALLING THE ONE-PIECE CUSTOM DOOR PANEL
Before fitting the custom panel, the dishwasher must be installed underneath the cabinet.
With this installation, the custom panel extends 1-13/16” inches above the dishwasher control panel, as
illustrated at right.
This installation also leaves a 2” gap between the top of the dishwasher and the
cabinet. We recommend that you install the 2” fill strip that comes with the unit
between the upper edge of the dishwasher and the counter to hide the top of the
dishwasher and further reduce water noise.
NOTE: Do not fasten the dishwasher to the cabinet until after you have installed
the door panel.
1. Remove the custom panel and parts from the packaging.
2. Move the insulation on the back of the custom panel.
3. Slide the handle support bracket to the inside top of the panel.
4. Insert the screws through the support bracket and the panel.
5. Fit the door handle to the screws and secure tightly.
6. Remove the rubber gaskets from inside the dishwasher door and discard.
7. Remove the second and fourth screws from the inside top of the
dishwasher door (as illustrated) and discard.
8. With the door slightly open, position the panel with the holes in
alignment with the door holes and secure it in place with 2-12”
squeeze clamps on both sides.
9. Insert the 1-1/2” screws partially through the dishwasher door.
10. Loosen the clamp on one side enough to align the screws with
the holes in the panel.
11. Secure the screws.
12. Repeat steps 9 and 10 for the other side.
13. Close the door and, if necessary, adjust for square by adjusting
the front levelling legs for proper height clearance.
14. Fasten the dishwasher to the cabinet (see the owner’s manual).
Dishwasher door
2nd
screw
4th
screw