Dishwasher installations, Installing a custom wood panel – Eurotech Appliances EWF272EL User Manual
Page 34
34
Specifications are subject to change without notice. See owner’s manual for additional details.
INSTALLING A CUSTOM WOOD PANEL
To install the custom wood panel, follow the steps below.
1. Attach the handle (A) to the wood panel. (It is best to
use a handle instead of a knob.)
2. Remove the second and fourth screws (B and C) from the
inside top of the dishwasher door and discard.
3. With the door slightly open, position the wood panel with
the holes in alignment with the door and secure it in
place with 2-12” squeeze clamps on both sides.
4. If you are installing a 30-1/16” high panel, it should
extend 1-13/16” above the control panel. It’s a good idea
to take this measurement before you proceed.
5. Insert the 1-1/2” screws supplied with the unit through
the panel and door.
6. Secure the screws.
7. Close the door and, if necessary, adjust level by adjusting
the front levelling legs for proper height clearance.
8. Fasten the dishwasher to the cabinet.
Dishwasher Installations