Epson Equity 320SX PLUS - Manual (Page 173)

Destructive tests
Format
Media analysis
Force bad tracks
Non-destructive tests
Performance
Seek
Read/verify
Check test cylinder
Before performing any destructive test, the program displays
the following messages:
W A R N I N G
All data on hard disk you have
specified may be lost...
Do you still want to continue (Y/N)?
Press Y and Enter to begin the test. Press N and Enter to stop
the operation.
Caution
You should not run any of the destructive tests on a SCSI
hard disk drive.
Hard Disk Parameters
The program may ask for the following parameters:
Disk drive identifier
Disk drive type
Interleave factor
Bad track list
Start cylinder number
End cylinder number
Start head number
End head number
Each parameter is described below.
Performing System Diagnostics B-13