Epson Equity 320SX PLUS - Manual (Page 180)

The controller displays one of the following messages when
an error occurs during a diagnostics procedure:
Address mark not found
Attachment failed to respond
Bad ECC on disk read
Bad sector flag detected
Controller has failed
Drive activity failed
ECC corrected data error
Requested sector not found
Reset failed
Seek operation failed
Write fault on selected drive
If you see one of these error messages, check the drive,
controller, cables, and power connectors. If you still get an
error, contact your dealer.
Floppy Disk Diognostics
Floppy disk diagnostic tests may be destructive or non-
destructive. Destructive diagnostics destroy data on the
diskette, but non-destructive diagnostics do not. The
following table lists which tests are destructive and which are
not.
B-20 Performing System Diagnostics