Epson Equity 320SX PLUS - Manual (Page 35)

When the system has successfully completed its self test, you
see the following prompt:
Press <Del> to start SETUP
Do not press any key yet. If MS-DOS has already been
installed on your system, you’ll see a prompt to enter the
date. (For information about loading the operating system,
see your MS-DOS manuals.)
If there is no operating system on your computer, you see an
error message. Ignore the message for now. Follow the
instructions below to turn off the computer and then go on
to Chapter 2 for instructions on running the SETUP program.
Note
If your computer’s configuration does not match the
information stored in the computer’s CMOS RAM (defined
through the SETUP program), you see an error message
and a prompt to press the F1 key. Press F1 to continue.
Then run the SETUP program to correct the information.
(See Chapter 2 for instructions.)
Turning Off the Computer
When you are ready to turn off your system, reverse the
sequence of steps you followed to turn it on. Turn off the
computer first, then turn off the monitor and any peripheral
devices.
Now go on to Chapter 2 and follow the instructions to run
the SETUP program.
1-18 Setting Up Your System