Epson Equity 320SX PLUS - Manual (Page 203)

3.
4.
5.
6.
Did you set the necessary jumpers on the main system
board? See Chapter 6 for more information.
Did you run the SETUP program to update your
configuration after installing the card? See Chapter 2.
If you used the option card to add an external device to
your computer, did you use the proper cable to connect
the device to the card’s connector on the back panel?
Did you perform the correct setup procedures for the
software you are using with the option card? If necessary,
see your software manual for instructions.
Mouse Problems
If you have trouble with your mouse, check the following:
1. Make sure that your mouse is securely connected to its
port on the back of the computer. Also, make sure you
have connected it to the correct port. See Chapter 1 for
more information.
2. If the mouse is connected properly, make sure that
jumper J4 on your computer’s main system board is set
correctly for your mouse. See Chapter 6 for more
information.
3. Did you install the mouse driver correctly? See your
software manual and the documentation that came with
your mouse for instructions.
4. If you’re still having trouble, check the documentation
that came with your mouse for any troubleshooting
information, or contact your dealer.
C-18 Troubleshooting