Eddie Bauer Enspira - Manual (Page 17)

30 31
With weakest hand at belt
path, tilt and push the
child restraint forward and
back, and from side to
side. If the seat belts do
not loosen, your child
restraint should be secure.
NOTE: Some “play” from
front to back or about an
inch from side to side is
acceptable. If it moves
more, review “Knowing
Your Vehicle Belts” and
“The Locking Clip”
sections.
After checking for hot
seat and buckles, secure
child as described in “Securing Your Child in the Child
Restraint” section.
5
WARNING !
Using this child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it, can result in
serious injury or death.
4
Push down firmly on the
child restraint and pull up
on belt to tighten. For a
manual belt, refer to
“Knowing Your Vehicle
Belts” section. Pull up on
shoulder strap to remove
any slack.
Rear
-Facing Use:
5-35 lbs.
(2.3-16 kg),
19-36” (48-91 cm)
NOTE: Locking clip is
shown installed.
1
2
3
Rear-Facing Installation with
LATCH: Install LATCH Belt
Do not use the LATCH
system along with the
adult lap or lap/shoulder
belt.
To thread LATCH belts:
Pull the seat pad off the
front corners of shell.
Reach under pad, pull
one LATCH hook
between rear harness
slot and buckle strap.
LATCH adjuster can be
on either side, but belt
should not be twisted.
Route entire LATCH
belt through the upper
slot in side of shell.
continued on next page.
4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 33