Eddie Bauer Enspira - Manual (Page 22)

41 40
With knee still in child
restraint, attach hook to
anchor in vehicle. Push
down firmly and tighten
top anchorage strap.
To adjust top anchorage
strap: See “Adjusting Top
Anchorage Strap” section.
5
Place one knee in the child
restraint and push down
firmly while pulling up on
the loop to tighten belt.
6
Forwar
d-Facing Use:
22-40 lbs.
(10.1-18 kg),
34
-43” (85.1-110 cm),
Ov
er 1 y
ear of age
.
4
Fasten one LATCH belt
hook to the anchor in the
vehicle seat located in the
vehicle seat bight. Repeat
for other side of child
restraint. See your vehicle
owner’s manual for
locations and more
information. With weakest hand at
belt path, tilt and push
the child restraint
forward and back, and
from side to side. If the
LATCH belts do not
loosen, your child
restraint should be
secure.
NOTE: Some “play”
from front to back or
about an inch from side
to side is acceptable.
If the child restraint does
not remain tight, do not use the child restraint in this
seating location with this LATCH system.
7
WARNING !
LATCH hooks MUST be securely fastened.
Failure to do this can result in serious
injury or death.
After checking for hot
seat and buckles, place
your child in the child
restraint as described in
the “Securing Your Child
in the Child Restraint”
section.
8
9
To release LATCH:
Remove child from child
restraint. Press down
firmly on adjuster side
of child restraint and
press release button on
adjuster to release
tension as shown.
Unhook LATCH from
bar.
4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 43