Eddie Bauer Enspira User Manual

Page 28

Advertising
background image

52

53

Work pad around headrest
and remove from plastic
shell.

Hand wash with warm sudsy water, rinse clean and air
dry. Do not use bleach or other harsh cleaners. Do not
dry clean.

Spot clean harness straps. Do not machine wash.

Replace seat pad by reversing order; Starting from
bottom of child restraint, slip pad on shell; tuck in pad
around harness adjuster. Pull pad up and around
headrest. Attach the elastic straps on both sides. Make
sure pad is under headrest and replace lower harness
guides. Put pad on headrest. Replace body pillow and
upper harness guides. Rethread harness (see belt-
positioning booster section).

5

1.

If your child restraint is not held securely

by the belt:
Press down firmly on the child restraint and remove all the
slack in the belt. Make sure the belt buckle is not up against
the child restraint where the belt cannot be tightened.
Review “Locking Clip” and “Adjusting the Top Anchorage
Strap” sections. If you cannot secure the child restraint
tightly, move it to another seating location.

2.

If the child restraint buckle or harness

adjustment lever sticks or you cannot get the straps
tight enough around child:
DO NOT LUBRICATE. Check around buckle and harness
release lever for dropped food, sticky spilled drinks, dirt,
leaves, etc. Clean with warm water and/or remove object
with tweezers. If you cannot get the harness to adjust and
remain tight with the buckle securely locked, do not use the
child restraint.

3.

If your harness twists or ropes:

Straighten the harness each time you put your child in the
seat to help prevent twisting. Lock the buckle and tighten
harness and it will be ready for next use.

4.

If your infant sits too upright in the rear-facing

position:

If your vehicle seat slopes so
much that your infant is sitting
upright, you may place a rolled
towel under the front of the
child restraint so that the level
line on the shoulder belt guide is
level (horizontal). Check often to
be sure padding is still in place
and the vehicle belt is tight.

WARNING

Using padding that tilts the child restraint
farther back than the level-to-ground line
can result in serious injury or death.

Troubleshooting

!

4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 55

Advertising
This manual is related to the following products: