Enterasys Networks FN 100 - Manual (Page 28)

The FN100 Chassis View
2-12 Managing the Hub
Figure 2-6. Device Find Source Address Window
The Device Find Source Address window displays the following information:
Component
Displays the type of interface through which the specified MAC address is
communicating. This field will report Bridge.
Port Instance
Displays the bridge port index number on which the specified MAC address was
found.
To use the Device Find Source Address window:
1. In the Address Mode field, select the format of the Source Address you wish
to find, either MAC or Canonical.
2. In the Enter Address text box, enter the Source Address you wish to find in
the appropriate XX-XX-XX-XX-XX-XX format.
3. Click on the Find It! button. A “Processing Request” message opens in the
status bar at the bottom of the window.
NOTE
If you enter the MAC format of a specified address, and then click on Canonical,
NetSight Element Manager will do the address conversion for you, from the Ethernet
hexadecimal format to the Token Ring Canonical format. The same is also true if you enter
the Canonical format of a specified address and then select MAC.