Enterasys Networks FN 100 - Manual (Page 51)

Configuring a Workgroup 5-3
Workgroup Configuration
3. Choose the Type of workgroup being created or modified. This determines
whether ports in this workgroup will forward only multicast packets, only
unicast packets, or both multicast and unicast packets. The following are your
possibilities:
• All — ports in this workgroup will forward both unicast and multicast
packets.
• Multicast — ports in this workgroup will forward only multicast packets.
• Unicast — ports in this workgroup will forward only unicast packets.
4. If necessary, use the Refresh button to deselect any ports you have
previously selected in the Port Selection area.
5. In the Ports In Workgroup area, click on the selection boxes corresponding
to the ports you would like to include in this workgroup. Each port is identified
by index number. Note that you cannot select the Network Management PPP
port for inclusion into a workgroup.
6. Click on Add if you are adding a new workgroup, or on Apply if you are
modifying an existing workgroup. New workgroup entries will be added to the
Workgroup Table, and changes to existing workgroups will be reflected in the
Workgroup Table.
7. Repeat steps 1-6 to add or modify any additional workgroups.
Deleting a Workgroup
In the Workgroup Table, highlight the work group you would like to delete. Click
on Delete, the highlighted work group will be deleted. To have this change
reflected in the Workgroup Table, click on
Refresh . The currently defined
workgroups will be displayed.