Extron electronic IPL T S Series - Manual (Page 19)

2-7 IPL T S Series • Installation and Operation
PRELIMINAR
Y
2-7
Ethernet/LAN
b
LAN Activity LED — A blinking yellow LED indicates LAN activity.
c
LAN connector — An RJ-45 connector for a network connection. Use an
Ethernet straight-through cable to connect to a switch, hub, or router, or an
Ethernet crossover cable to connect directly to a PC.
COM1
LAN
00-05-A6-00-00-02
POWER
12V
.5A MAX COM1
TX RX TX RX
COM2
COM2
3 2 4
1 2 3 4 5 6 7 8
RJ-45 Connector
Insert
Twisted
Pair Wires
Pins:
Side View
Straight-through Cable
(for connection to a switch, hub, or router)
End 1 End 2
Pin Wire Color Pin Wire Color
1 white-orange 1 white-orange
2 orange 2 orange
3 white-green 3 white-green
4 blue 4 blue
5 white-blue 5 white-blue
6 green 6 green
7 white-brown 7 white-brown
8 brown 8 brown
Crossover Cable
(for direct connection to a PC)
End 1 End 2
Pin Wire Color Pin Wire Color
1 white-orange 1 white-green
2 orange 2 green
3 white-green 3 white-orange
4 blue 4 blue
5 white-blue 5 white-blue
6 green 6 orange
7 white-brown 7 white-brown
8 brown 8 brown
Figure 2-9 — RJ-45 connector wiring
d
Link LED — A lit green LED indicates a good LAN connection.
Serial Communication
e
Captive screw connector — Plug a 3.5 mm, 5-pole captive screw connector
into this socket for serial ports 1 and 2 (IPL T S2) or serial ports 3 through 6
(IPL T S6) connections. Pacing and handshaking are not supported via the
captive screw connectors.
N The two IPL T S2 captive screw connectors are in parallel with the two 9-pin D
connectors. For each serial port on the S2 use either the captive screw connector
or the 9-pin D connector, but not both.
f
COM1 — 9-pin D connector for serial port 1
g
COM2 — 9-pin D connector for serial port 2
h
COM3 — 9-pin D connector for serial port 3 (S4 only)
i
COM4 — 9-pin D connector for serial port 4 (S4 only)
IPL T S Series interface devices can be used to control display devices, switchers,
and other A/V equipment via an RS-232/RS-422/RS-485 connection.