Emulex Printer Server - Manual (Page 13)

Command Reference Guide 7
ip_addr ] [set] [enabled |disabled]
change service “servc_name” [port port_num ]
[TCPport_num] [ password “pass_txt” ] [ protocol ]
[ enabled | disabled ]
44
crash 300 10
define node node_name [nfserver |npserver] 16
define port port_num appletalk backspoof [enabled
|disabled]
27
define port port_num appletalk tbcp [enabled
|disabled]
27
define server authorize protocol [all |none
|specific ] [enabled |disabled]
26
define server bootp n m [temp] 38
define server dhcp n m [temp] 39
define server gateway [load_dump] ip [ip_address
| none]
41
define server load [selfload |TFTP [put] |decnet] 40
define server netware [default |802.2 |snap |802.3
|ethernet_II ether_type] 34
define server netware forms [enabled |disabled] 35
define server netware nds “tree_name” 36
define server netware password “pass_txt” 31
define server netware pserver [auto |disabled |3.x
|4.x]
35
define server netware rediscover minutes 34
define server netware required [enabled |disabled] 33
define server netware rprinter [enabled |disabled] 34
define server preferred dump ip ip_address 42
define server preferred load ip ip_address 40
define server software file_name 41
define service “servc_name” appletalk type “prn_type” 45
delete node node_name [all |ip ip_address |tcpip
|gateway |nfserver |npserver |syslog]
16
delete service “servc_name” 45