Emulex Printer Server - Manual (Page 30)

24 Command Reference Guide
Other Options
Enable or disable special printer server options.
>
Server>> [set |define |change] server options
option_list
[all |enabled |disabled]
option_list Enter a list of options from the available options
section below.
all Enables all options.
enabled Adds the specified option to the existing option
list. If not specified, the existing list is replaced
by the new one.
disabled Removes a specified option from the existing
option list. The default is none -- all options
disabled.
Available options are:
0 Enable unknown frames (bypass protocol frame
filter).
2 Enable use of 0’s (not 1’s) in host portion of IP
broadcast address.
3 Pack Group Codes into smallest number of bytes.
4 Host Initiated Requests announce supported
services.
5 Print Information-Only messages to the console
port.
6 Print Non-Fatal error messages to the console
port.
7 Reserved.
8 Reserved.
9 Inhibit round robin port allocation.
10 Enable fast TCP/IP acknowledge to speed up
38400 baud and parallel ports.
11 Force an IP (or ARP) datagram to be sent out
when route cannot be found.
15 Enforce LAT Circuit Timer (slows performance
for bridged LAT usage and prevents timeouts).