When using the strap, When using the batteries, When using the strap when using the batteries – Epson PhotoPC 3100Z User Manual

Page 13

Advertising
background image

Introduction

5

R4C7850
Rev. C

A5 size

INTRO.FM

4/27/01

Pass 3

R

Proof Sign-off:
K. Pipa CRE Tsutagawa
K. Pipa
CRE R. Hopley

Never adjust controls that are not mentioned in
the operating instructions.

Do not touch your camera’s flash with your
fingers, or any other object, or allow the flash to
become dirty. Using the camera under any of
these conditions can damage the flash.

If you accidentally touch the flash, or if it becomes
dirty, be sure to clean it with a soft, dry cloth
before using the camera.

If you plan to use the camera and options in
Germany, observe the following:

To provide adequate short-circuit protection and
over-current protection for these products, the
building installation must be protected by a 10 or
16 Amp circuit breaker.

Bei Anschluss des Produkts an die
Stromversorgung muss sichergestellt werden,
dass die Gebäudeinstallation mit einem 10 A-
oder 16 A-Sicherung abgesichert ist.

If the liquid crystal solution contained in the
display panel or in the LCD monitor leaks out and
gets on your hands, wash them thoroughly with
soap and water. If it gets into your eyes, flush
them immediately with water.

When using the strap

Note the following when using the camera strap.

Do not swing the camera about. This can damage
the camera or other objects, or cause injury.

Do not pull or tighten the strap too much when
wearing it; this can cause serious injury.

Keep the strap away from children.

When using the batteries

Note the following when using and batteries.

Read all relevant safety and operating
instructions before using the batteries.

Do not use manganese batteries (IEC R6).

Do not charge primary (non-rechargeable)
batteries.

To avoid fire or electric shock, do not use batteries
that are leaking or damaged in any way.

Only use EPSON Ni-MH batteries according to
the directions in this manual.

Advertising