Epson PhotoPC 3100Z - Manual (Page 96)

5-10 Using Images on Your Computer
L Proof Sign-off:
K. Pipa CRE Tsutagawa
K. Pipa
CRE R. Hopley R4C7850
Rev. C
A5 size COMPUTER.FM
4/27/01 Pass 3
3. Open the connector cover on the side of the
camera. Insert the other end of the USB cable into
the interface connector. Make sure that the shape
of the cable connector corresponds to the shape of
the interface connector.
c
Caution:
Be sure to position the cable correctly before
inserting it into the connector. Otherwise, the
cable and connector may be damaged.
4. Set the camera’s dial switch to and turn the
camera on.
The first time you connect your camera to your
computer, the computer may display some windows
while it associates the USB driver to the camera. This
is normal and only happens the first time the camera
is connected.
If you have not yet installed the USB driver, a message
asking you to locate the driver will appear. If this
happens, cancel the operation and disconnect the
camera from the computer. Close all applications, then
install the USB driver following the instructions in
“Installing the Software for Windows Users” on page
5-3 or “Installing the Software for Macintosh Users”
on page 5-5.
When you connect the camera, the green indicator
light next to the viewfinder blinks while the
connection is being established. While the camera is
connected, stars move across the display panel at the
top of the camera.
c
Caution:
Keep your camera and computer away from potential
sources of electromagnetic interference, such as
loudspeakers or the base units of cordless telephones.
Disconnecting the camera from your computer
After you are finished using the camera with the
computer, be sure to disconnect the camera properly.
Follow the steps in the appropriate section below.
connector cover