Epson Perfection 1200U - Manual (Page 25)

18
8. When the scanner software installation is
complete, you see this screen:
Click Restart . The Screen Calibration utility starts. (Your Macintosh will not
restart until after you calibrate your screen.) You must calibrate your screen and
scanner to reproduce images closely matching the originals.
9. In the following window, move the slider to the right or left until the shades of the
horizontal gray stripes appear similar. View the screen from a short distance. The
gray stripes will not perfectly blend together; however, try to make the two tones
match as closely as possible.
10. Click OK to register the calibration setting. Then your Macintosh automatically
restarts.
You will not need to change the screen calibration again as
long as you continue to use the same monitor. If you need to
recalibrate your screen at a later time, select Screen
Calibration in the EPSON Scanner folder.
11. Now you can install your creative software and view your electronic manuals as
described on page 19.
before calibration after calibration