EMC CLARiiON 300002039 - Manual (Page 3)

About EMC Navisphere Software
The following EMC® server-based software is available on the server
support CD that shipped with your storage system or your upgrade kit
(for AX-series systems upgrading to Navisphere Manager):
Š Navisphere® Storage System Initialization Utility
Š Navisphere Host Agent
Š Navisphere Server Utility
Š Admsnap Utility
Š Navisphere Command Line Interface (CLI)
About the Navisphere Storage System Initialization Utility
For CX3-series and CX-series Fibre Channel storage systems, use the
utility to discover storage systems, and set network parameters (IP
address, subnet mask, and default gateway).
Note : For CX-series storage systems, an authorized service provider must
install and run the Initialization Utility.
For AX-series storage systems, use the utility to discover storage
systems, set network parameters (IP address, subnet mask, and default
gateway), and create management user accounts. In addition, for
AX150 iSCSI storage systems, use the utility to set network parameters
for the storage system’s iSCSI data ports.
You can run the Navisphere Storage System Initialization Utility from
the server support CD or you can install it on a server that is connected
to the storage system. We recommend that you install the utility on at
least one server that is connected to the storage system.
EMC CLARiiON Server Support Products for Solaris Server Installation Guide 3