EMC CLARiiON 300002039 - Manual (Page 34)

Installing and removing the Navisphere Server Utility
This section describes how to install the Navisphere Server Utility on
a server connected to a CX3-series, CX-series, or AX-series storage
system.
Installing the Navisphere Server Utility on a Solaris server
EMC recommends that you install the most recent version of the
Navisphere Server Utility software that is appropriate for your
configuration. You can download the most recent version from either
the software download page on the Powerlink website (CX3–series and
CX-series) or on the support website (AX-series storage systems). You
can also install the software from the server support CD (any storage
system); however, the CD may not contain the most recent version for
your configuration.
1. Log in to the server as superuser (root).
2. If any previous revision of the server utility is installed on the
server, remove it before continuing.
Note : To verify if the server utility is installed, enter the pkginfo |grep
HOST command.
3. To download the software for CX3–series or CX-series storage
systems, do the following:
a. On the Powerlink website, select Support > Software
Downloads and Licensing and navigate to the Navisphere
Server Utility download section, which may be in either
the CLARiiON Navisphere Server Utility section or the
CLARiiON Navisphere Manager
section.
b. Select the appropriate Navisphere Server Utility version to
download and select the option to save the zip file to your server.
c. At the command line prompt, navigate to the directory where
you saved the zip file and unzip the file.
unzip Sun_HOSTUTIL- version.zip
34 EMC CLARiiON Server Support Products for Solaris Server Installation Guide