EMC CLARiiON 300002039 - Manual (Page 6)

Note : The server utility runs on servers attached to CX3-series, CX-series, and
AX-series storage systems. CX3 model 10 systems must be running FLARE
OE 03.24.010.5.xxx or later. CX3 model 20 systems, CX3 model 40 systems,
and CX3 model 80 systems must be running FLARE OE 03.22.xxx.5.yyy or
later. CX200, CX300-series, CX400, CX500-series, CX600, and CX700 systems
must be running FLARE 02.16.xxx.5.yyy or later.AX150-series systems must
be running FLARE 02.20.xxx.5.yyy or later. AX100-series systems must be
running FLARE 02.16.xxx.5.yyy or later.
About the Admsnap Utility
The Admsnap Utility is an executable program that you can run
interactively or by a script to manage SnapView® clones and snapshots.
The Admsnap Utility resides on the servers connected to the storage
system with the SnapView driver installed.
Use admsnap commands to:
Š Scan for new storage devices
Š Make storage devices inaccessible to the server operating system
Š Flush cache data to disk
Š List current snapshot devices
Š Map and unmap to a SnapView session
Š Start and stop a SnapView session
6 EMC CLARiiON Server Support Products for Solaris Server Installation Guide