Efficient Networks 5100 Series - Manual (Page 46)

SpeedStream Router User Guide
- NAT & NAPT:
Enable concurrent NAT and NAPT
Note Depending on your configuration, NAT is sometimes enabled by default. Disable NAT only in
advanced situations where your ISP has assigned static IP addresses.
2. To continue to the Connection Name window, click Next.
Specify Connection Name
1. On the Connection Name window, enter
a name for the new connection.
2. To complete the configuration process for
the RFC-2684 Bridged protocol, click
Next.
The VC Wizard window displays.
Finish
On the VC Wizard window, click Finish. •
•
The Current Configuration window
displays the new connection in the first
available row.
Configure RFC-2684 Routed
Protocol
RFC-2684 Routed is an IP-driven protocol
with different encapsulation than RFC-2684 Bridged, but does route traffic. Since this protocol does not
support DHCP, the IP address must be manually entered.
On the Protocol Selection window, click RFC-2684 Routed; then click Next.
The 2684 Routed window displays.
Enter IP Information
1. On the 2684 Routed window, enter the IP
address and subnet mask. You may also
enter the [optional] default gateway and
DNS server addresses.
2. To continue to the Interface Options
window, click Next.
Select Interface Options
1. On the Interface Options window, select
the desired options:
36