Efficient Networks 5100 Series - Manual (Page 51)

SpeedStream Router User Guide
- Active Mode:
In enabled, the router will receive routing updates on the selected interface and will broadcast
regular routing updates to other routers. If not enabled (default), the router will receive
routing updates on this interface, but will not broadcast routing tables.
NAT/NAPT:
Enable Network Address Translation (NAT) and/or Network Address Port Translation (NAPT).
For more information on using NAT and NAPT, see page 65. •
•
•
- Disabled:
Disable both NAT and NAPT (for example, if setting up static routes).
- NAT:
Enable NAT only and specify the destination IP address for incoming packets on the selected
WAN interface.
- NAPT:
Enable NAPT only to handle multiple addresses based on port forwarding rules.
- NAT & NAPT:
Enable concurrent NAT and NAPT
Note Depending on your configuration, NAT is sometimes enabled by default. Disable NAT only in
advanced situations where your ISP has assigned static IP addresses.
2. To continue to the Connection Name window, click Next.
Specify Connection Name
1. On the Connection Name window, enter
a name for the new connection.
2. To complete the configuration process for
the PPPoE/Client Only protocol, click
Next.
The VC Wizard window displays.
Finish
On the VC Wizard window, click Finish.
The Current Configuration window
displays the new connection information.
Configure PPPoE / Bridge Only
This mode passes PPPoE traffic through to
the LAN over Ethernet or another PPPoE
client on the computer to maintain the PPP
connection.
On the PPPoE Type window, select Bridge only.
The Interface Options window displays
41