Eurotech Appliances VIPER / VIPER-LITE PXA255 - Manual (Page 43)

VIPER Technical Manual Detailed hardware description
© 2007 Eurotech Ltd Issue E 43
FPIF-LVDS-TX details
The FPIF-LVDS-TX enables LVDS displays to be connected to the VIPER.
The FPIF-LVDS-TX in combination with the FPIF-LVDS-RX allows the VIPER to drive a
TFT or STN LCD flat panel display up to 10 meters away.
When using the FPIF-LVDS-TX, ensure the VIPER JP2 jumper is set to select
3.3V to power the LVDS transceiver. Do not select 5V as damage will occur to
the LVDS transceiver.
The connectors on the following pages are shown in the same orientation as
the picture above, unless otherwise stated.
Connector Function
JP1 TX strobe selection
JP2 Cable power selection
JP3 MSL selection
J1 VIPER LCD output cable connector
J2 LVDS Hirose connector
J3 LVDS MDR connector
J2
J3
JP1
J1
JP2
JP3