Hawking Technology HNC700PT User Manual
Hawking Technology Cameras
Advertising
Table of contents
Document Outline
- CE Mark Warning
- Installation
- How to Use This Camera
- Appendix
- Hardware Installation
-
- Software Installation
- In this manual, "User" refers to anyone who has access to the network camera, and "Administrator" refers to anyone who has access rights to configure the network camera and grant user access to it.
- Check Network Settings (even if the device is already connected)
- Although the network camera may already be connected following the software installation procedure, administrators should ensure that the network settings in the configuration page are correct, including the subnet mask, IP address of the gateway, and DN
- Add a Password for Security
-
- Authentication
-
- Installing the Plug-in
- In Windows, during the initial access to the network camera, the web browser may prompt you for permission to install a new plug-in for the network camera. Whether or not you are prompted to install the plug-in will depend on the Internet security settin
- Primary User’s Capabilities
- Main Screen with Camera View
-
- Administrator’s Capabilities
- Configure for Optimal Performance
- Definitions in Configuration
- System Parameters
- User Group Administration
- Video Codec Parameters
- Motion Detection
- Application Setup
- UPnP and DDNS Settings
- Remote Controller
- Viewing System Parameters
- Factory default
- A. Troubleshooting
- B. Frequently Asked Questions (FAQ)
- C. URL commands of the Network Camera
- Capture update Snapshot of JPEG image
- Query status of the digital input
- Drive the digital output
- Restore factory default settings
- Restart system
- Page URL
- System resource URL
- General format of command URL
- System configuration URL
- Security configuration URL
- Network configuration URL
- DDNS & UPnP configuration URL
- Audio/Video configuration URL
- Camera control URL
- Image quality configuration URL
- Application configuration URL